Filter tower (plug & play)

ulmatec

Filter tower (plug & play)

The "Plug & Play" filter towers by ULMATEC are used when pointed suction of smoke, dust and cooling lubricants is not practical or sufficiently possible in processing of large workpieces. In contrast to previous room venting systems, it is no longer necessary to place a piping system. The filter towers are delivered completely pre-installed and ready for operation.

Just erect, connect and use!

The employers' liability insurance association recommends filter towers according to the layer venting principle, since this is not only cleaning the air in the circulation principle but also achieves heating costs savings up to 70%.

ULMATEC filter towers are low-noise and simple to operate. Both contamination-dependent power control and a radio remote control or remote maintenance via Wifi are possible as options and make the filter towers a complete hall suction system for welding, cutting, grinding and processing of workpieces with cooling lubricants.

If the work flow in your production ever changes, this is not a problem with the filter towers of the FT type. The fork-lift strap or crane eyelets make it possible to set them up quickly and easily anywhere.

Filter tower smoke - FTR
Filter tower smoke - FTR
ulmatec

Options:

  • Room air sensor
  • Heavy-load rollers
  • Compressed air compressor
  • Filling level monitor
  • Residual dust sensor
ulmatec

Your benefits at a glance:

  • Delivered immediately ready for operation
  • No piping installation
  • Portable and therefore usable in different areas of the hall
  • Expansible with heating/cooling module
ulmatec

Systems variants:

Filter tower fog - FTN
Filter tower fog - FTN
Filter tower dust - FTS
Filter tower dust - FTS